ProjectSite visit—Prepared byVitalDraft Solutions, in collaboration with MD SurveysCoordinate system—
About this viewer
This interactive 3D viewer presents the documentation captured during the site visit of : a dense LiDAR point cloud, photo-realistic Gaussian-splat scenes of each capture segment, ground control points measured with an RTK rover and the SHARE S20 scanner, and the proposed design linework (DXF) of the project.
Please note
The data represents the conditions on the visit date only. Later changes on site are not reflected.
The drawing shown is the project proposal (design intent). It is not an as-built drawing; an as-built DXF will be added to this deliverable when available.
Point clouds and splat scenes come from mobile scanning georeferenced with RTK GNSS. They are provided for visualization, review and coordination and do not replace a signed and sealed survey. Do not use them for construction staking or boundary determination.
The optional satellite map is a third-party online service (Esri, Maxar and others) shown for context; it can be offset from the survey data.
This material is confidential and prepared for the client’s use. Do not redistribute without written authorization from VitalDraft Solutions and MD Surveys.
How to use it
On a phone or tablet:one finger rotates, two fingers pinch to zoom and drag to pan. The layers panel opens with the ☰ Layers button; the quality starts adapted to your device and you can change it (or tick Auto-adjust).
Navigate:left drag rotate · right drag or Shift+drag pan · wheel zoom. Use Fit, Plan and 3D at the top of the panel.
Layers (☰ button): switch each layer on or off and set its opacity: point cloud, splats, DXF design, control points and satellite map. The ➤ button next to a segment flies the camera to it.
Compare design and reality: lower the point-cloud opacity or switch the splats off to see the proposed linework against the surveyed points; switch on the satellite map for context.
Splats load progressively when switched on (they are large): wait for “ready”. A dedicated graphics card is recommended; use a recent Chrome or Edge.
Performance indicator (top-right corner): shows the frames per second and an estimate of the graphics memory in use. A high load (yellow / red) means the graphics card is close to its limit: the view becomes sluggish or layers may fail to load. To lighten it, show only the segments you are reviewing (untick the others or press ⏏ Unload to free the graphics memory). Splats are the heaviest layer.
Which view for what: the point cloud is the smoothest and most reliable layer; in Plan view you see the complete structure of the site at a glance. The Gaussian splats are an experimental technology still under development: they show more visual detail, depending on your hardware and graphics card. Walk mode adds detail that the point clouds cannot define. The reference grid is hidden automatically while splats are shown (it can be confusing) and comes back with the point cloud, to help you stay oriented.
Walk mode (🚶 button): click the ground where you want to start, then W A S D or the arrows to move, Shift to run, E/Space and Q/C to raise or lower your height, mouse to look around (click once to capture the mouse), right click or Esc to leave. On phones and tablets: left stick to move (push it to the edge to run), right stick to look, ▲ ▼ to change your height and ✕ Exit to leave.
Control points are GPS (RTK GNSS) shots taken on site: cyan = RTK rover, pink = SHARE S20. They show name and elevation in the project datum (see above) and are used to check the cloud against the real coordinates.
Final delivery: the final as-built drawing will be shown here, so you can verify that it matches the data of the visit (the field data) and the surveyed points.